Hotpoint HWF Fridge Water Filter

£49.99
Tired of average water quality? The Hotpoint HWF will produce great tasting water and ice and elevate your beverages to new heights. Replace on a regular basis and everyone will notice your superior quality beverages. Add one to your basket today and leave average water quality behind.
SKU
HOTPOINT/HWF-MWF
  • Buy 2 for £48.99 each and save 2%
  • Buy 3 for £47.99 each and save 4%
Hotpoint HWF Fridge Water Filter is available to buy in increments of 1
  • The Hotpoint HWF Fridge Filter fits Hotpoint refrigerators with a round white plastic filter, typically mounted inside the refrigerator at the rear of the compartment, above the top shelf
  • The Hotpoint HWF filter is exactly the same filter as the GE MWF with a different label. You may receive a GE branded model depending on our availability, but they are the same cartridge
  • Recommended 6 month replacement
  • Certified by NSF International to meet or exceed NSF/ANSI Standards 42 and 53
  • Features a simple push-and-twist installation
More Information
Replaces
9991 9996 101057A 101057-A 101300-0110
469991 469996 101300A 101300-A 197D6321P001
46-9991 46-9996 AP3859302 AP3967843 GERF-100
GWF GWF01 GWF06 GWFA GWFDS
HWF HWFA MWF3PK MWFA MWFAP
MWFDS PC40677 PC61278A PS981638 PS983115
PT11577906 WF287 WF-287 WR02X11020 WR02X11287
WR02X11290 WR17S12 WR2M3552 WSG-1  
When to Change

Installation and replacement procedure for the HWF fridge water filter:

  • Slowly turn the old cartridge 1/4 turn to the left (counter clockwise). Note: Do not pull down on the cartridge.
  • Remove and discard the old filter (the water will shut off automatically).
  • Peel off the protective cover from the new cartridge.
  • Fill the new replacement cartridge with cold water to allow for better flow immediately after installation (you can use tap water).
  • Line up the arrow on the cartridge with the cartridge holder. Note: Do not force it up into the holder.
  • Turn the filter 90 degrees right (clockwise) until the cartridge stops. Do not over tighten.
  • Run water through the dispenser for 3 minutes to purge the system.
  • Check the filter area for leaks.
  • Reset the filter status light by pressing and holding the Reset Water Filter button for 3 seconds.

 When to change a filter: There is a replacement indicator light for the water filter cartridge on the temperature control panel. The filter cartridge should be replaced when the replacement indicator light turns red, or every 6 months, or if the flow of water to a dispenser or icemaker decreases.


Important: It is essential that operation, maintenance and filter replacement be carried out in accordance with manufacture's recommended procedures and guidelines for this product to perform as advertised. Failure to do so may void warranty.

Contaminants / Specs

The HWF Hotpoint water filter reduces the following health related contaminants:

  • 96.00% of Chlorine Taste and Odour
  • 99.10% of Particulates (Class I)
  • 93.00% of Mercury
  • 99.00% of Lead
  • 99.00% of Lindane
  • 94.00% of Atrazine
  • 99.99% of Cysts
  • 99.00% of p-Dichlorobenzene
  • 98.00% of Carbofuran
  • 98.00% of 2,4-D
  • 93.00% of Toxaphene
  • 99.00% of Asbestos
  • 96.00% of Benzene
  • 99.00% of Alachlor
  • 98.00% of Turbidity

Tested and Certified by NSF International against NSF/ANSI Standards 42 & 53. As with all built-in refrigerator water filters, the GE MWF does not remove Fluoride.


Note: The filter produces cleaner, better tasting and healthy drinking water & ice.


Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

Write Your Own Review
You're reviewing:Hotpoint HWF Fridge Water Filter
Your Rating